
Particles reach an outlet where they are not wanted.
Dust or powder accumulates in bends and constrictions.
A filter, cyclone or separator fails to achieve expected performance.
Particles cause localised wear or erosion.
Droplets are distributed unevenly over a product or surface.
Material remains in pipes or process equipment.
The flow does not transport larger particles sufficiently.
The cause of fouling or deposition is not clear.



The trajectories of individual particles or droplets.
The flow of the carrier gas or liquid.
The influence of particle size, density and initial velocity.
Deposition on walls and internal components.
Separation and collection efficiency.
Particles escaping via an outlet.
Residence time and accumulation in the system.
Locations with an increased risk of erosion.
The influence of turbulence on particle dispersion.

Repositioning inlets and outlets.
Designing bends to be wider or more gradual.
Adjusting the transport velocity.
Optimising the geometry of a cyclone or separator.
Adding guide vanes or internal components.
Repositioning or aiming spray nozzles differently.
Distributing the particle load more evenly across filters.
Reducing deposition and wear in critical areas.



Filters and dust extraction systems.
Cyclones and other particle separators.
Pneumatic transport.
Powder and grain processing.
Spray and drying processes.
Droplet separators.
Industrial ventilation.
Flue gas and cleaning systems.
Wear and erosion research in pipelines.

We determine the relevant volume flows and operating conditions.
We inventory the properties and distribution of the particles or droplets.
We first calculate the continuous flow field of gas or liquid.
We then track the trajectories of representative particles or droplets.
We assess deposition, separation, escape and potential erosion.
We compare different geometries or operating conditions.
We present the results as particle trajectories, collection rates and practical recommendations.



Analysis of both the main flow and particle movement.
Experience with complex industrial multiphase flows.
Insight into deposition and separation mechanisms that are difficult to observe.
Comparison of improvements before modifying the installation.
Clear explanation of the technical cause behind the problem.
Direct consultation with an experienced CFD specialist.
Would you like to understand particle and droplet transport in your system?
Tell us about your system, its operating conditions and the problems you have observed. We will discuss how CFD can identify the causes and assess practical improvements.
