
The measured concentration varies by position in the system.
The end product does not have a constant composition.
The mixing process takes longer than expected.
Added components do not reach the full volume.
Dead zones or poorly mixed areas develop within the system.
An introduced substance flows too quickly to the outlet.
The cause of local over- or under-concentrations is unknown.
Increased stirring or pump power provides hardly any improvement.



The development of concentration over time.
The spatial concentration distribution of liquid or gaseous components.
The time required to achieve the desired homogeneity.
Dead zones and areas with insufficient mixing.
Short-circuiting between inlet and outlet.
The residence time distribution within the system.
The influence of inlet position, flow rate, and flow direction.
The performance of agitators, mixing elements, and internal components.

Adjusting the shape, position, or speed of an agitator.
Changing the position or direction of a feed.
Adding internal mixing elements or baffles.
Reducing dead zones by modifying the geometry.
Optimising the ratio between different volume flows.
Distributing an additive more uniformly across the system.
Preventing short-circuiting between inlet and outlet.
Balancing mixing time and energy consumption.



Chemical and industrial reactors.
Mixing vessels and stirred tanks.
Water purification and wastewater treatment.
Dosing and injection systems.
Storage tanks and buffer vessels.
Gas and vapour dispersion.
Ventilation and air quality.
Food and process industry.

We collect data on geometry, flow rates, and material properties.
We determine which components are being mixed and the requirements for homogeneity.
We build a CFD model of the flow and concentration transport.
We analyse concentration fields, mixing time, and residence time.
We identify dead zones, short-circuiting, and poorly mixed areas.
We compare potential modifications to inlets, agitators, or geometry.
We translate the findings into concrete design or process improvements.



Analysis of both flow behaviour and concentration distribution.
Technically substantiated comparison of design variants.
Over thirty years of experience with mixing and industrial flows.
Clear visualisation of mixing processes that are difficult to measure.
Practical recommendations within the process constraints.
Direct consultation with an experienced CFD specialist.
Would you like to understand concentration distribution and mixing in your system?
Tell us about your system, its operating conditions and the problems you have observed. We will discuss how CFD can identify the causes and assess practical improvements.
